4 Cavity Hot Runner Injection Mold , Sub Gate DME HASCO Base
1. The part name: Printer accessories (plastic injection mold)
2. Plastic material: ABS+PC
3. Cavity material: H13 HRC48-52
4. Mold life: 1000k shots or according to customers quantity
condition to decide it with saving cost for our customers.
5. Gate type: Point gate, Sub-gate, direct gate, fan gate, edge
gate, valve gate, tip gate etc according to our customers requires.
6. Mold base standard: LKM Local standard, DME or HASCO,Customize
according to customers' requirements
7. Standard of mold accessories: LKM, DME, HASCO, MISUMI,
Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS,
MOLD-MASTER, MERKLE, Parker, HPS, LKM, EUCHNER, RJG, cilpres,
NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO
JIS standard, PUNCH etc according to our customers requires.
The part name: Printer accessories
Mold type: Plastic Injection Mould
Part Material: ABS+PC
Locating ring Dimension: Ф100
KO Pattern: 200*200
Sprue Radius: SR 19
Ejection type: ejection pins, ejection sleeves.
Mold construction description: cold runner system with sub gate, 2
plates, and many sliders, inserts and shut off area. there are many
thin steel in the mold.
Gates/Runners: cold Runner
This product is made of ABS+PC plastic material and it is one of
the components of the reputable brand Printer. The mold
construction is complicated and there are many inserts, sliders and
very thin steel, so it has a very high technical requirement for
the mould design. The mould is a cold runner mould with the best
water cooling system and the part can be molded by automatically.
This part has very high size requirements, the defect showed below
will not be acceptable, for example, weld line, Dark Sport,Sliver
Marks,Gas Trap Effect,Visible Ejector Marks,Deformation,Short shot
Filling,Burnt Streaks,Sink Marks,Flash,Over dimension,Under
dimension,Stress Crack etc. Moreover, the product finishing surface
must meet the requires more than SPI-SPE-B2.
This mould is made in Shiny Mould Factory. It is a mould exported
to Europe, with complicated structures and high quality requests.
Customer needs mold life to be over 1 million shots. We can ensure
this mold life and give warrant to our customer that once some
mould components are broken during working, if it is caused not by
the operation fault from the workers, we can provide new mould
components to them free of charge.